Looking to increase the performance of your 2022-current 992 GT3? Look no further than this Porsche 911 992 GT3 Wheel & Tire Fitment Guide. With Performance street and track fitments with our 20” lineup as well as Hardcore track fitments using 19” wheels. We have you covered no matter what you plan on using your 992 GT3 for. With Forged options like the VS-5RS and EC-7RS, we are reducing unsprung and rotational mass and increasing wheel widths in select fitments. Unlock the full potential of your GT3 with a set of Apex wheels in a fitment below.
Brake Clearance Information
The factory 6 piston 408mm steel and 410mm PCCBs require 20" wheels for proper clearance. Read our article for more info.
19" Wheels can be run on this chassis when factory front brakes are replaced with aftermarket kits such as those from AP Racing Essex.
Rear Axle Steering (RAS) Clearance
All 19" & 20" APEX wheels are optimized to clear rear axle steering.
Wider fitments for enhanced performance
Our most popular fitments for the 992 GT3 that work with both the 408mm Steel and 410mm PCCB options. With two rear wheel sizes to choose from to best match the tire you plan to use, we have you covered for both street and track use.
Tires
Track focused fitments that require significant modifications
Our Hardcore Track fitments for those 992 GT3's that see considerable amount of track time and have gone to an aftermarket front brake setup. With reduced diameter, we get less weight and consumable cost as well as better sidewall support for those track tires or Pirelli Slicks. Unlock more performance from your GT3 today.
Brake Clearance Information
In the engineering phase of wheel development we 3D scan factory brakes and review 2D aftermarket brake templates in order to optimize our barrel profiles and spoke curvatures. As a result, our wheels offer massive brake clearance so you can run the smallest possible wheel diameter. The following brakes have been tested and confirmed: